JARACAL

Goeie dag.

Vriend van my is opsoek na patrone of komponente om te herlaai vir n 7.65 Argentine Mauser.
Weet een van julle waar n man so iets kan kry.

Lekker dag.

Antwoord uit milsurps.com

I do not nor have I ever used VV powders in my mod 91 mauser. I usually make my own cases from any good reformable cases 30-06, .270 Win, .280 Rem., ect. using a RCBS file trim die, hack saw and file. I also aneal the heck and shoulder before re-forming. Yes they are just a tiny bit small but in my experience of over 40 years they work just fine. I have shot a few of the heavy bullets that you mention but my hunting loads are always either a 150 grain soft point or 123-125 grain fmj or soft point. May I suggest that you work up your load starting low and going where you decide to go, a 91 is a very well made and fine rifle but not as strong a action as a 98. For powder I use IMR 4320 or IMR 4895 but I would imagine that there are lots more that can be used. My primers are almost always CCI but most any Large Rifle will do except for magnum.

Daar was verlede week nog n paar pakke doppe by Kloppers in Bloemfontein se wapenafdeling.