Hoop hier is 'n iemand wat al te doen gehad het met die scopes wat kan help.
Ek het onlangs een tweedehands by iemand gekoop. Scope is nog baie netjies en hy wou opgradeer. Het glo net 1 keer met hom gaan jag na hy hom Aug 2019 gekoop het.
Ek dink ek verstaan nou waarom
Hier is my vrae:
1. Hoeveel clicks moet ek draai om 1 duim te skuif op 100y?
Die boek sê 8 x clicks op 100y maar ek ondervind dat 4 x clicks wel 1 duim skuif op 100y. Of lees ek dalk net die boek verkeerd? Of is daar iets anders fout?
Bore sight your scope, or place a target about two feet square
at 25 yards. Fire a shot at the bullseye. After removing the
adjustment caps, make the necessary adjustments to the
Windage and Elevation knobs. Remember, with a click
adjustment value of 1/8 inch at 100 yards it will require four
clicks to move the same 1/8-inch distance at 25 yards (32
clicks will move bullet strike 1 inch at 25 yards).
NOTE: The click value is indicated on top of the adjustment knob.
Place a target at 100 yards (or meters) if shooting a
centerfire cartridge, or at 50 yards if shooting rimfires, slugs,
muzzleloaders or 300 BlackOut subsonic loads
2. Hoe "Verify" julle die bullet drop syfer?
Volgens die handleiding moet ek 6" stel vir elke duim wat ek uit is op 400y. Ek was vandag 2.5" laag so ek het my drop syfer met 15 gelig. Toe is ek heeltemal van teiken af.
Verifying Your Table Selection
For long-range shooting, verify the actual bullet drop at
750 yards* (686 meters). Set the scope at maximum
magnification. If your group is low, increase the Drop Number
by the number of inches it is low. (If you are 2 inches low with
a 200 Drop Number, change your Drop Number to 202.) If
the group is high, decrease the Drop Number by the number
of inches it is high. (If you are 2 inches high with a 200 Drop
Number, change your Drop Number to 198.) The change
needed will be measured in inches regardless of the units set.
The BC from the Cartridge List with altitude compensation
should not need changing during 750-yard verification.
Often it is difficult to find a suitable place to target shoot at
750 yards, whereas 400, 500, or 600 yards may be easier to
locate. Use the chart below to make adjustments to your Drop
Number when verifying calibration at these distances.
Verifying Trajectory Calibration at Long Range
Target Distance
For each inch, bullet impact is
LOW, INCREASE Drop Number by:
750 - 1”
600 - 2”
500 - 3”
400 - 6”
3. Hoe goed hou die scopes hulle Zero?
Ek moes vandag weer 1" aanpas na my vorige Zero laas Saterdag.
4. Wie is die Burris Agent in RSA?
Lyk my ek gaan van hulle Warranty moet gebruik maak.
Every Burris optic is covered by the Burris Forever Warranty™. We will repair or replace your Burris optic if it is damaged or defective. The warranty is automatically transferred to future owners.
No repair or replacement charge
No warranty card needed
No receipt needed
No questions asked
Hoop daar is iemand daar buite wat kan help. Ek luister graag.
maar ek dink dis veilig om te sê daar is iets fout.
