JARACAL

Naand almal.
Ek weet hier is al baie geskryf oor torque van aksie skroewe en so aan, maar ek voel ek wil nog steeds graag vra.
Ek het n turkse okkerneut kolf op myne en ek wil graag my aksie skroewe na gaan.

Ek probeer fotos bysit en vra asseblief raad vir n waarde om hulle te torque.

Ek het n oordentlikke torque wrench.

Hou my oor oo die grond.
Lekker aand.

Askies. sukkel met die fotos klein maak.

Hier

En nog

Gaan loer op Google en jy sal heelwat besprekings sien soos die hieronder.

https://www.brownells.com/.aspx/lid=108 ... _Gunsmiths

ek het die Al voorheen opgesit. ek het dit gekry op Internet so alle erkenning aan die outeur.

The question has been asked on several occasions
what the torque for bedding screws and scope bases
should be so I though this might be helpfull.

"NOTE" These are based on full engagement of threads.

Wood, Fiberglass or Synthetic stock without bedding pillars-
40 inch-lbs.

Wood, Fiberglass or Synthetic stock with bedding pillars -
up to 65 inch-lbs.

Hard-use service-type rifles in synthetic with pillars-
up to 65 inch-lbs.

Law enforcement & military rifles are 65 inch-lbs on each
of the guard screws.

On rifles with three guard screws the middle screw should 
be only slightly tightened.

Scope base screws 30 inch-lbs "MAX"

Windage screws 30-40 inch-lbs "MAX"

Scope ring screws (Aluminum Rings) 10-15 inch-lbs "MAX"

Scope ring screws (Steel Rings) 15-20 inch-lbs "MAX"

Note' If scope base and ring Screws have less than 5 threads
of engagement they should be replaced with longer ones.

Barrel to receiver Torque 35 ft/lbs minimum to 95 ft/lbs Max.

If an anti seize compound is used instead of a light oil use 65
ft/lbs max to prevent over torquing.

I hope this will help
J E CUSTOM

Hop die geweer so 2 of 3 keer liggies op die recoil pad en laat hom net so regop staan, draai voor 35 pond en agter 30 pond.

Inlbs Kaptein?
Dankie
Wardeer