Nishon wrote:Is QL and OBT a software programme or a method of load developement? Its the first time I'm reading of this.If it is another method could yourll be kind enough to explain it to me.
Ha I read through that you sent me on PM and I did not know that was the OCW method, I actually used it before I had a chronograph to develop loads for my 243.
Now I did get great results with my 243 making use of the OCW(I learnt about it from a friend that called it the trial method

).
Now I use QL it is much faster and cheaper to use. I figure out a load on QL that is safe, fire it over a chronograph, adjust Ql powder file to match my results, get a node and load it at that, shoot over crony again normally you have to recalibrate QL again as the volume changes therefore burn rate changes just to match up your setup. I have never( using QL ) needed more than 10 shots to get hunting accuracy constantly in my rifle.
So I know OCW works, but at the cost of bullets today and taking into account availability, It is very expensive, and I am very glad that I could make use of QL to work up an accurate load for my 375H&H with Barns TSX 350gr as I can not fire more that 12 shots with precision with that load as it hurts my shoulder of the bench after 6 shots, and by shot 10 I can feel I want to flinch and you cant do load development over shooting sticks.
works great on lighter calibers though expensive.
All you need for QL is
Caliber
Barrel length measured with bolt closed but firing pin back(tensioned) not factory length
use cleaning stick to measure
Cartridge volume in gr H2O of a fire formed cartridge
The bullet brand and weight to be used and product code if you have it (ex Hornady V-max 87gr #22440) jammer manne ek kon myself nie help nie

Powder type and if possible Lot number as it helps most QL users calibrate the burn rate faster.
The max COL of round were ogive is touching lands if possible
max COL that fits your mag
do not measure COL on ogive, measure the overall length
Primers to be used
And at least 2 different loads with the abovementioned components with speed measured over your chronograph
Now my recommendation is to use S365 and a magnum primer with the bullets heavier than 75gr Because That is what I would have used and because I use magnum primers in everything, if my 9mm Para would have been able to take LR primers I would probably be loading it with CCI 250 too.
that is my 2c worth for the day